Trimet Aluminium SE, Essen, has developed a new aluminium alloy for crash-relevant components and applications.
The wrought alloy „trimal-53“ is suitable for structural components and applications with high strength and excellent deformation capacity. The aluminium specialist thus now supplies a material for which there is a growing need, particularly in the vehicle manufacturing sector. The new Trimet alloy meets every major carmaker’s need for light-metal materials to produce safety-related vehicle components.
„trimal-53“ meets requirements for crash applications
The new wrought alloy „trimal-53“ (AlMgSi) achieves strengths of more than 270 megapascals. With an elongation of ten percent and more, this new material also meets the high standards required of the compression behavior. As such, „trimal-53“ achieves a higher component strength than conventional alloys with the same wall thickness. Furthermore, the strength can be maintained while reducing the wall thickness. This makes it possible to reduce the weight of the component without lowering safety standards.
New alloy for the most diverse dimensioning objectives
With „trimal-53“, Trimet has developed an alloy that can be used for the most diverse dimensioning objectives and for manufacturing structural components at low cost. The components produced from this material can be thermally or mechanically joined with other materials such as cast nodes. If necessary, Trimet can also modify the alloy to meet the specific requirements of the application.
“With this new alloy, we are catering to the growing need for aluminium materials to make structural components and meeting the high requirements of all major manufacturers,” says Thomas Reuther, member of the Executive Board at Trimet Aluminium SE. „trimal-53“ has been developed from the so-called 6xxx series in the research and development division of the family-run company. Aluminium wrought alloys in this series are established materials in the vehicle manufacturing sector. They feature good strength and formability and are also corrosion resistant. This alloy group is used in many different application areas and can be easily recycled.
Especially suitable for extruded profiles
The main alloying elements magnesium and silicon are also responsible for the basic strength of „trimal-53“. Other elements produce the finely grained structure of the material and give it its comparatively benevolent quenching behavior. Homogenization creates a microstructure with predominantly round structured phases. This has a positive effect on the subsequent forming process. The wrought alloy „trimal-53“ is particularly suitable for extruded profiles in accordance with BMW delivery specifications (GS93047.HST, formerly: WS02003.TypB), but also for other application areas (e.g. VW-TL116.C24 and DBL-4919.30).
Trimal-38 (AlSi8ZnMn) has the potential to reduce energy demand and to increase cost efficiency by avoiding heat treatment after casting.
ST Extruded Products Group, Step-G for short, has once again achieved certification to the Iris standard with level silver at its Bonn site.
Sustainability is one of the core values at EGA, with three pillars: safeguarding the environment, social responsibility and good governance.